information and inspiration
for students, teachers and hobbyists
About Tools Products Activities Galleries Projects FAQ Links Contact Facebook LinkedIn  flickr

 

Assembly and Operating Instructions for HiViz.com Kits

 

For best results in viewing images, we recommend using the Firefox browser.

 

Parts for the Quick-Connect Kit for the Multi-Trigger

 

Assembly instructions for other kits

Parts Guide

 

Below is a list of the parts included in the Quick-Connect Kit for the Multi-Trigger.

 

Click here for the Parts Guide for the PCB for Multi-Trigger Kit (MT-PCB2).

 

Click here for replacement or additional connectors. Click here for replacement or additional cable.

 

We may occasionally make changes to the parts list without notice in order to improve the product.

 

HiViz.com

Part No.

Name/Description

Photo

Quantity Use Notes
35MP

3.5mm mono (male)

3.5mm mono male connector

2 These connectors are used for the microphone cord and the external trigger input.

For the microphone, the sleeve is connected to ground and the tip to the microphone input.

For an external trigger, the sleeve is connected to ground and the tip to the positive output line of the trigger.

35MF 3.5mm mono (female) 3.5 mono female connector 2 These are the female counterparts to the connectors above. Use them on jumper cables coming from the microphone and external trigger inputs on the PCB.  
35SP 3.5mm stereo (male) 3.5 stereo male connector 2 These connectors are used for the two photogate cords. One is for the interrupter-style photogate and the other for the individual emitter and detector style. The tip is connected to +9 V, the ring to the photogate input, and the sleeve to a 470-ohm dropping resistor that then goes to ground on the PCB.
35SF 3.5mm stereo (female) 3.5 stereo female connector 1 This is the female counterpart to the connectors above. Use this on a jumper cable coming from PT and LED2 on the PCB.  
RCA-mr

RCA (male)

RCA male connector

1 This is used as a connector on the cable from a flash unit or camera to plug into any of the four RCA panel jacks or female RCA connectors. The sleeve is connected to ground and the tip to the desired output.
RCA-mf

RCA (female)

RCA female connector, red 1 This is the female counterpart to the connector above. Connect to a jumper cable from D3 on the PCB.  
 

Red and black 22-ga, single strand wire

Red and black hookup wire 2 ft each color This hookup wire is used for the 4 jumper cables from the PCB. The wire will be cut into 6-in sections.  
  Green 22-ga, single strand wire Green hookup wire 6 inches This wire is needed for the jumper for the photogate cable.  
  2-conductor cable 2-conductor cable 3 ft This cable is used to extend the microphone from the PCB.  
  3/32-in dia heat-shrink tubing heat-shrink tubing 2 in The heat-shrink tubing is used to insulate the splices on the microphone cable.  
  3/16-in dia heat-shrink tubing 3 in

 

 

 

 


About Tools Products Activities Galleries Projects FAQ Links Contact Facebook LinkedIn flickr
 
 
copyright © 1995-2018 HiViz.com