Assembly and Operating Instructions for HiViz Kits
Connecting linear taper potentiometers to breadboarded circuits (<v10)
Note: These instructions are for kits before v10.
|
The legs of the linear
taper potentiometer are numbered 1-3 in the diagram
to the left. The view is looking down on the potentiometer
with the rotator shaft pointing toward you.
The coordinates for the connection of each leg to the breadboard are given below. Refer to the linked photo to view the breadboard circuit of interest.
Before connecting the linear taper pot to the breadboard, the pot to be replaced must be removed from the breadboard. |
| Kit (before v10) |
Pot to be replaced |
Connections |
| 1M
|
Leg 3 of the linear pot connects to 30J. Leg 2 of the linear pot connects to the red 9-V column. |
|
| 1k
|
Leg 1 of the linear pot connects to 11J. Leg 2 of the linear pot connects to the blue column adjacent to the red 9-V column. |
|
| 10k
|
Leg 3 of the linear pot connects to 8A. Leg 2 of the linear pot connects to the blue ground (-) column. |
|
| 100k
|
Leg 3 of the linear pot connects to 9J. Leg 2 of the linear pot connects to the red 9-V column. |
|
| 100k
|
Leg 1 of the linear pot connects to 11J. Leg 2 of the linear pot connects to the red 9-V column. |
|
| SPG1-DU
or SPG2-DU with coarse-fine delay control (also see PGU instructions) |
1M  |
Leg 3 of the 1M linear pot connects to 30J. Leg 2 of the 1M linear pot connects to the red 9-V column. |
100k  |
Leg 3 of the 100k linear pot connects to 15J. Leg 2 of the 100k linear pot connects to the blue column adjacent to the red 9-V column. |
Assembly instructions for other kits