Assembly and Operating Instructions for HiViz Kits

 

Connections Chart for the Camera Opto-Switch

 

The trigger cable of the Opto-Switch connects to Hiviz breadboard circuits (v10) as given below.

 

Note that the hole placements for the SK2, SPG1, SPG2, TPG, LAT, and DU individually are the same as for the combinations SK2-DU, SPG1-DU, SPG2-DU, TPG-DU, and LAT-DU.

 

Trigger circuit	Output	Note	Connections
			Positive	Negative
DU - Delay unit	Immediate		20B	ground column
	Delayed		23D
SK2 - Sound trigger		You must also remove the wire from 5C to 8C to disconnect the SCR.	5D
SPG1,2- Schmitt trigger photogate			4A
TPG - Transistor photogate			3H
LAT - Light-activated trigger			5A
CBP1,2 - Crossed-beam photogate			3H
MT - Multi-Trigger	Immediate		16B
	Delayed		18D
	Photogate		4A
	Sound	You must also remove the wire from 27D to 29D to disconnect the SCR.	27E