HiViz.com - Kits - Flash Trigger Cable Kits

The HiViz.com WorkShop

New Sound Trigger 4, Crossed-Beam Sensor, Dual Light Sensor kits

Flash Trigger Cable Kits

These kits are for preparing a cable to connect the flash output of one of our trigger circuits to a PC jack. The cable kit with 3.5mm plug will work for the Multi-Trigger 3. The cable kit with RCA plug will work for the Sound Trigger 2, Photo Gate 2i, and Delay Timer 2s.

The flash trigger cable kits include a PC-type connector for the flash, either a 3.5mm mono plug or RCA plug, 3-ft of 2-conductor cable, and heat-shrink tubing. Assembly is required.

If your flash unit doesn't have a PC jack but does have a hot shoe, the hot shoe adapter shown to the right can be used together with a flash trigger cable for flash triggering.

If your flash unit is one of the Vivitar models 283, 285HV, or 3700, you'll need a Vivitar PC-1 cord to connect to your flash unit. Click here for one possible source. If you're triggering your flash wirelessly or your flash unit has a 3.5mm synch jack, see this page for 3.5mm cables.

Select this cable kit for the Multi-Trigger 3.	Select this cable kit for the Sound Trigger 2, Photo Gate 2i, and Delay Timer 2s.

PC cable kit with 3.5mm plug - $4.95 (parts, unassembled above / assembled below)	PC cable kit with RCA plug - $4.95 (parts, unassembled above / assembled below)

Select a flash cable kit $4.95), a hot shoe adapter ($9.95), or a combination of flash cable kit ($13.90). The latter combination saves you $1 over purchasing the items separately.